AG-IIR001C

Product Name:Hospital Baby Nursing Medical Incubator

Baby Incubator body is divided into two stories. There are two rectangular holes on the baby compartment, then it will form air convection circulatory system from head to foot.

The controller is equipped with the axle flowing blower, heated tube and the water trough; the baby compartment is equipped with the hood, it is convenient to take down the crib. Under the driving of the axle flowing blower, the heat and moisture circulate along such a direction from top to bottom, from left to right in the baby incubator, and then reach the balance of the temperature and the humidity. In the space of the axle flowing blower where the air pressure is negative, there is a hole having a diameter of 13 mm, from where a small amount of air outside enter the baby incubator after purifying, achieve the purpose that CO2 does not exceed standard.

Fixed the infusion support and tray module on the control cabin with inner hexagon socket screw. (use two piece M8×30 inner hexagon socket screw)

Unscrew the rotary knob on the infusion pole, after adjust the high and direction, screw fixed it again, use inner hexagon screw loosen four bolt of configuration tray equipment, put tray on the infusion pole and fixed it.

Lifting the constant temp hood, stuck the front pull type plastic tray baby bed on the shake table, put on mattress, press down support locking plate, constant temp hood will closed after self-locking bolt break away from limit.

1)Specification:

1.Microprocessor based servo controlled temperature system

2.Temperature displayed by LED

3.Alarms functions : Power failure; over temperature; temperature deviation; temperature sensor failure;fan failure

4.>37°C temperature setting

5.A keypad lock prevent inadvertent changes the setting

6.Humidity is adjustable continuously

7.Heating power displayed on panel

8.A second thermal cut-off function for more safety

9.The infant bed inclination angle is adjustable

10.Trough for pulling and pushing ,which is convenient to add the water and wash

11.Fan with low noise and long life-span

12.Temperature deviation and over temperature could be amended in front panel directly

13.Silence/reset button for alarms

14.six operating windows,two side operating windows can be swiveled

15.Heater is electrically cut-out if air temperature inside incubator exceed 40°C

16.Cabinet with three drawers

17. Phototherapy up side unit

2)Standard configuration:

Main body(including the transparent hood, control system, infant bed, water trough),

I.V.pole, mattress, cabinet, silence castors

3)Optional parts:

1.phototherapy down sides

2.RS232(485)conncector

3.Tray/pole

4.Infant bed pulled from side door

5.Infant bed pulled from side and front door

6.Double wall hood

4)Technical data:

1.Power supply : AC 110/220V  60/50Hz

2.Power input :  ≤420VA

Operating conditions:

1.Environment temperature: 20°C~30°C

2.Environment relative humidity: 30%~75%RH

3.Environment air velocity of flow: <0.3m/s

4.Air Temperature control range: 25°C~38°C

5.Temperature fluctuation: +/-0.5°C

6.Uniformity of mattress temperature: ≤0.8°C

7.Humidity accuracy: ≤10%RH

8.Warm-up time: ≤45min

9.Internal noise level: ≤55dB

10.Infant bed tilt angle : +10o

11.Mattress size: 65cm(L)×37cm(W)

12.Trough capacity: 1200ml

13.Air filter:0.5um